Pixhawk == PX4-FMUv2

• It is based on a 168MHz 32bit STM32F427 Cortex M4 processor with 256KB of RAM.
• Pixhawk hardware project was started at ETH Zurich by Lorenz Meier and MikeS.
• Original Pixhawk was manufactured by 3D Robotics.
• It is an open source hardware, so there are many clones and copies available on the market.
• It has two ancestors, APM (the hardware) was an Arduino based flight controller made by DIYDrones/3DRobotics, and PX4-FMUv1 and PX4-IO.
• Pixhawk is essentially a single board version of PX4-FMU + PX4-IO module, and thus it's also know as PX4-FMUv2 (FMU = Flight Management Unit).
• There's a version of PX4IO called PX4IOAR which is specifically designed for AR.Drone.
• Pixhawk uses Hirose DF13 connectors which is designed as a surface mount connector and not meant to be plugged/unplugged frequently. Since it's prone to connector/socket/wire breakage, and difficult to handle, a lot of people dislike it. |